7/9/2008 RS-603 REV A. 1 C3-RS-601 PROFESSIONAL REMOTE CAR STARTER With Two Way data Port
7/9/2008 RS-603 REV A. 10 +12V Master Door Lock Switch X X Splice Splice Cut the Existing Lock Wire To Door Lock Motors Cut the Existing Unlock W
7/9/2008 RS-603 REV A. 11 A. PROGRAMMING TRANSMITTER: Note: This remote start system will only retain the last 4 remote transmitters programmed. If
7/9/2008 RS-603 REV A. 12 FEATURE “III” PROGRAMMING: Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position. 1. Push the Vale
7/9/2008 RS-603 REV A. 13 ** This will be used when connected to an Autopage CI3 compatible Two-way data module that will recognize the tach signal
7/9/2008 RS-603 REV A. 14 SHUTDOWN DIAGNOSTICS The unit has the ability to report the cause of the last shutdown of the remote start system. Ente
7/9/2008 RS-603 REV A. 153. Sitting in the vehicle, turn the ignition switch to “ON” or “RUN” position. But do not start the engine. 4. Step on the
7/9/2008 RS-603 REV A. 16than Park or Neutral while the key is in the ignition cylinder however, if the key is left in the ignition switch and the d
7/9/2008 RS-603 REV A. 17 It is recommended to have a minimal digital service plan on your cell phone Your RS-601 is C/3 compatible and will o
7/9/2008 RS-603 REV A. 18 Winner of the BEST OF INNOVATIONS 2008 CES
7/9/2008 RS-603 REV A. 19 Auto Page, Inc. 960 Knox Unit #B Torrance, CA 90502 www.autopageusa.com Toll Free Tech Support Hotlin
7/9/2008 RS-603 REV A. 2 TABLE OF CONTENTS This device complies with part 15 of the FCC rules. Operation is subject t
7/9/2008 RS-603 REV A. 3 INTRODUCTION INSTALLER WARNINGS This Remote Starter System is designed to be installed on fuel-injected vehicles with an
7/9/2008 RS-603 REV A. 4 INSTALLATION DIAGRAM
7/9/2008 RS-603 REV A. 5 WIRING Keep wiring away from moving engine parts, exhaust pipes and high-tension cable. Tape wires that pass through h
7/9/2008 RS-603 REV A. 6Connect the BROWN wire to the accessory wire in the vehicle that powers the climate control system. An accessory wire will
7/9/2008 RS-603 REV A. 7The WHITE/BLACK wire provides an instant shutdown for the remote start, whenever it is grounded. Connect the wire to the ho
7/9/2008 RS-603 REV A. 8FACTORY SECURITY DISARM SIGNAL OUTPUT –(Factory Default Setting) -- This wire is designed to disarm a factory installed sec
7/9/2008 RS-603 REV A. 9If the vehicle has the General Motor VATS system installed, you will need to by -pass the system while the vehicle is oper
Comments to this Manuals